Cubitech 4CH Triplex Manual de usuario descargar pdf (Pagina 4)

NOTE:

1. This unit is designed to detect an intruder and activate an

alarm control panel. Being only a part of complete

system, we cannot assume responsibility for theft or

damages, should it occur.

2. Specifications and design are subject to change without

prior notice.

No. 4-46 Feng Jen Rd, Kao Tarn Village,

Jen Wu Hsiang, Kaohsiung Hsian, Taiwan, R.O.C.

Tel:886-7-3721111~3 Fax:886-7-3721114

Web Site : http : // www.sengate.com

E-mail : service @ sengate.com

Designing / Manufacturing

Taiwan Security Net Co., Ltd.

10.DIMENTIONS

9.SPECIFICATIONS

MODEL

2PH-100BS

2PH-150BS

Dimentions

Simultaneous breaking of 2 beams

W 100x H 247 x D 100 mm

LED pulsed beam, Double modulation

Heating Unit (HT-150)

Max. Arrival Distance

Current Consumption

Power Supply

Response Time

Alarm Output

Functions

Alignment Angle

Mounting Positions

Wiring

Weight

Standard Accessories

Attenuation LED

Tamper Output

3000 ft.(1000m) 4500 ft.(1500m)

85mA (max)67mA (max)

10.5V ~ 30VDC ( Non _Polarity )

50msec ~ 700msec ( Adjustable )

Dry connect relay NC./ NO. 0.2A / 28VDC

Contact action: 1 To 3 sec .

Dry connect relay NC. 0.2A / 28VDC

Action : cover is detached.

Horizontal ±90°, Vertical±10°

-13℉ to +131℉ ( -25℃ to +55℃)

Indoor / Outdoor

Terminals

U-Shaped brackets x 4

Attenuation Sheet x 1

Screws ( 4x30 Self tapping ) x 8

Screws ( M4 x 20 ) x 8

300 ft. (100m)

600 ft. (200m)

450 ft. (150m)

900 ft. (300m)

63.7oz(1805g)Transmitter & Receiver

8.TROUBLE SHOOTING

Option

Trouble

Operation LED does not light.

( Transmitter Unit )

Alarm LED does not light

when the beam is broken.

( Receiver Unit )

Check Corrective Action

1. No power supply.

2. Bad wiring connection or broken wire, short.

1. Beam alignment is out.

2. Shading object between Transmitter and Receiver.

3. Optics of units are soiled.

4. Wrong beam frequency channel set up.

1. No power supply

2. Bad wiring connection or broken wire, short.

3. Beam is reflected on another object and sent into the

receiver.

4. Two beams are not broken simultaneously.

5. The beam interruption time is shorter than the set

response time.

6. Inline or stacked beam sensors set up with improper

frequency channel.

Detection System

Infrared Photoelectric

1. Bad wiring connection.

2. Change of supply voltage.

3. Shading object between Transmitter and Receiver.

4. A large electric noise source, such as power machine,

is located nearby Transmitter and Receiver.

5. Unstable installation of Transmitter and Receiver.

6. Soiled optics of Transmitter and Receiver.

7. Improper alignment.

8. Small animals may pass through the 2 beams.

1. Check again.

2. Stabilize supply voltage.

3. Remove the shading object.

4. Change the place for installation.

5. Stablize.

6. Clean the optics with a soft cloth.

7. Check and adjust again.

8. Set the response time longer.( Impossible in a

site where an intruder can run at full speed. )

1. Check and adjust again.

2. Remove the shading object.

3. Clean the optics with a soft cloth.

4. Readjust the DIP-SW for the right channel.

1. Turn on the power supply.

2. Check wiring.

3. Remove the reflecting object or change

beam direction.

4. Break two beams simultaneously.

5. Set the response time shorter.

6. According to the manual instruction and readjust the

channel.

1. Turn on the power.

2. Checking wiring.

Alarm LED continues to light

( Receiver Unit )

Intermittent alarms

Detection

Distance

Alarm LED

Red LED (Receiver) lights when an alarm is initiated.

Yellow LED (Receiver) lights when beam is attenuated

RF-Monitor Jack, Meter Monitor Jack output

A.G.C. circuit, Frost proof cover.

Operating Temperature

Outdoor

Indoor

2PH-100BQ 2PH-150BQ

300 ft. (100m)

600 ft. (200m)

450 ft. (150m)

900 ft. (300m)

3000 ft.(1000m)

4500 ft.(1500m)

85mA (max)67mA (max)

Selectable Beam

Frequency

4 channel

Unit : Inch(mm)

3.93" (99.85)

2.36"(60)

1.93"(49)

1.93" (49)

3.46 "(88)

3.94" (100)

9.72" (247)

2.7" (68.5)

No:A027B01-00

1 2 3 4

Comentarios a estos manuales

Sin comentarios

Cubitech 4CH Triplex Manual de usuario Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Grabadores de vídeo digital (dvr) Cubitech 4CH Triplex